Fusee Clock Set Up Page

Click on the Dial for a Pdf Version 

1/         Ensure clock is firmly fixed to the wall if necessary use a washer  (If it moves from left to right it will put the clock out of beat)

Make sure using a spirit level that the clock is true to the wall and is level on the top of the box. 

2/         Fit the pendulum by means of the bottom and side doors, ensuring that the top pin rests in the groove on the clock suspension block and the pin projecting from the mechanism locates in the pendulum slot.

This Photo Shows Correct application

3/         Start the clock going by gently swinging the pendulum, let it settle for about 5 minutes then observe if the beat sounds even, if not gently move the case until the desired sound is heard, tighten all fixing screws.

4/         To alter the time always move the minute hand, never touch the hour hand.

5/         To regulate timekeeping:

a/ Lower the pendulum bob if clock is gaining.

b/ Raise the pendulum bob if clock is losing.

© www.railwayclocks.net 2008

T 01386 760109 

Evesham WR11 7PA

Please note all material is the sole property of Railway clocks.net and must not be reproduced or copied without prior permission. ©2008

Specialist Conservation of your GWR, SR, LNER, LMS, BR, or any Railway Clock.